The Kick - Variable Voltage Mod Adapter
The Kick is an adapter for your standard 3.7V mod. You insert it between the positive side of your battery and top of your mod (never towards device spring).
- Use only IMR Batteries
- For 18650 mods, use 18500 IMR
- There is a small spring attached to the top, side edge of the Kick. This has been carefully designed and is an important part of the Kick for proper functioning. The spring must make contact with the grounded inner wall of the battery tube. If this spring does not make contact, the Kick will not function. Some devices have an anodized or painted interior. This can interfere with the ground connection. These coatings must be removed at the point of contact with the ground spring.
- To set the power: The adjustment potentiometer (blue box) is located on the top side of the Kick. In the center of the box is a white adjustment screw to be used for adjusting the Kick's power setting. The watts settings are marked ON THE CIRCUIT BOARD and can be seen around the pot/blue-box. NOTE: there are lines underneath each setting number, follow the lines to the corresponding watts setting. Turning the adjustment screw clockwise increases power and counter-clockwise decreases power. The settings range is from 5 watts to 10 watts. The Kick performs best with attys/cartos rated between 1.3 to 3.0 Ohms. You can use higher rated resistance but the Kick will not regulate well at the highest power levels if resistance is above 3 ohms. Unlike Variable voltage devices, the Kick does not need frequent adjustments. Once you find your preferred Power level, there is no need to constantly adjust it because the Kick will maintain that Power level even if you change attys/cartos and/or resistance.